Hi. I am looking to design a printed card which will highlight my cord management device (called the “DapWrap”) and show instructions for how to use it. The DapWrap units that are ordered will be inserted along with this printed card into mailers to send to customers. The optimal size for the card to fit in the mailers I am planning to use is 6 inches wide x 3 inches tall.
On one side of the card, I'd like to include two illustrations of the DapWrap device in use:
- As worn on earbuds when in use
- As used to secure bundled earbuds
I’ve attached two pictures for reference. I’d also like to include the logo (jpg attached) as well as text that reads: "Thank you for your order!” and “Stay untangled!" + the website "http://www.dapwrap.com".
On the other side of the card, I’d like to include a series of three illustrations showing how to use the DapWrap device. I envision three sections across the width of the card with the three illustrations and text descriptions for each step below the corresponding illustration. I've attached three pictures where I use my hands to show the steps. I believe illustrations will be better than just using actual snapshots of my hands manipulating the device – my thought is to have a sleeker/simpler looking drawn set of hands in the illustrations vs something too realistic to make it more fun/pleasing to the users to read. There may need to be some arrows in the drawings that assist in depicting the actions. The steps are as follows:
1) Attach: slip one end of cord through shorter elastic loop, then slide device to desired spot along length of cord
2) Wrap: bundle cord as desired, then stretch longer elastic loop through middle of bundled cord
3) Secure: further stretch longer elastic loop over and around opposite side of device
At the bottom of the page: “To Release: stretch longer elastic loop back over and off device; gently re-extend cord”
“Note: DapWrap can be used with earbuds, power cords and many other items where helpful to secure in a bundle”
In the pictures attached, the DapWrap device is shown with the logo printed on it. However, it is not necessary to replicate the logo in the actual illustrations – fine to just show a plain version for simplicity. Also, fine to simplify other elements in the drawing where helpful to keep the illustrations clean and simple.
I'm open to extra suggestions. I am not a designer or illustrator, so I am eager to find an expert to help me here. Thanks!